ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Removal And Installation|Page 11053 > < Removal And Installation|Page 11051
Page 4
background image

connectors at the floor connectors. The restraint system diagnostic tools must be removed prior to operating the vehicle over the road.

-

Diagnostics may be performed on seat systems other than the side airbag or the safety belt pretensioner (if equipped) system (lumbar, climate
controlled, heated, power seat track) with the seat installed in the vehicle as long as the restraint system diagnostic tools are installed under the
seats in the side airbag and safety belt pretensioner to floor connectors.

-

After diagnosing/repairing a seat system, the restraint system diagnostic tools must be removed before operating the vehicle over the road.

-

Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the diagnostic
procedure again.

1. Position the driver seat rearward.
2. Remove the driver seat front track to floor bolts.

3. Move and tilt the front seats to their highest and most forward position.
4. Disconnect the battery ground cable and wait at least one minute.

WARNING:  TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE BACKUP POWER SUPPLY
MUST BE DEPLETED BEFORE REPAIRING OR REPLACING ANY FRONT OR SIDE AIR BAG SUPPLEMENTAL RESTRAINT
SYSTEM (SRS) COMPONENTS AND BEFORE SERVICING, REPLACING, ADJUSTING OR STRIKING COMPONENTS NEAR
THE FRONT OR SIDE AIR BAG SENSORS, SUCH AS DOORS, INSTRUMENT PANEL, CONSOLE, DOOR LATCHES, STRIKERS,
SEATS AND HOOD LATCHES.

PLEASE REFER TO THE APPROPRIATE VEHICLE SHOP MANUAL TO DETERMINE LOCATION OF THE FRONT AIR BAG
SENSORS.

THE SIDE AIR BAG SENSORS ARE LOCATED AT OR NEAR THE BASE OF THE B-PILLAR.

TO DEPLETE THE BACKUP POWER SUPPLY ENERGY, DISCONNECT THE BATTERY GROUND CABLE AND WAIT AT
LEAST ONE MINUTE. BE SURE TO DISCONNECT AUXILIARY BATTERIES AND POWER SUPPLIES (IF EQUIPPED).

5. Disconnect the driver seat.

1

Remove the tie-strap.

2

Disconnect the driver seat side air bag electrical connector.

3

Disconnect the driver seat power seat track electrical connector.

Removal And Installation|Page 11053 > < Removal And Installation|Page 11051