Explorer Sport 4WD V6-245 4.0L SOHC VIN K SFI (2001)
5. Position the driver seat into the vehicle. Install all the seat track to floor bolts and hand-tighten them.
CAUTION: Use care when handling the seat and track assembly. Dropping the assembly or sitting on a seat not secured in the vehicle may result
in damaged components.
6. Connect the driver seat side air bag delete resistor and power seat electrical connectors.
1
Connect the driver seat power seat track electrical connector.
2
Connect the driver seat side air bag delete resistor electrical connector.
3
Tie-strap the wire harness.
7. Connect the battery ground cable.
8. Position the driver seat rearward.
9. Tighten the driver seat front track to floor bolts in the sequence shown.
1
Tighten the front inboard bolt.
2
Tighten the front outboard bolt.
10. Move and tilt the driver seat to its highest and most forward position.
11. Tighten the driver seat rear track to floor bolts in the sequence shown.
1
Tighten the rear inboard bolt.
2
Tighten the rear outboard bolt.
