Explorer Sport 4WD V6-245 4.0L SOHC VIN K SFI (2001)
2. Remove the rear wheel disc brake shield.
1
Drill out the rivet, (if present).
2
Remove the rear wheel disc brake shield.
Installation
1. NOTE: Because the rear wheel disc brake shield is held in position by the four rear wheel disc brake adapter bolts, a new rivet is not required.
Seal the rivet hole with Clear Silicone Rubber F7AZ-19554-CA or equivalent meeting Ford specification ESB-M4G92-A, and install the rear
wheel disc brake shield.
2. Install the rear wheel disc brake adapter.
