Explorer Sport 4WD V6-245 4.0L SOHC VIN K SFI (2001)
Ignition Cable: Service and Repair
Spark Plug Wire Remover
SPECIAL TOOL(S)
REMOVAL
1. With a twisting motion, use the special tool to pull the spark plug wire off the spark plug.
CAUTION:
^
Spark plug wires must be connected correctly. Mark the spark plug wires before removing them.
^
It is important to twist the spark plug wire boots while pulling upward to avoid possible damage to the spark plug wire.
2. Squeeze the locking tabs and twist while pulling upward to remove the spark plug wires from the ignition coil.
3. Disconnect the spark plug wires from the separators and remove the spark plug wires.
INSTALLATION
1. To install, reverse the removal procedure.
CAUTION: Be sure to orient the spark plug boots so the spark plug wires do not contact the exhaust manifold.
NOTE: Apply silicone dielectric compound to the inside of the spark plug and ignition coil boots of the spark plug wire.