Explorer Sport 4WD V6-245 4.0L SOHC VIN K SFI (2001)
Electronic Brake Control Module: All Technical Service Bulletins
Brakes - ABS Lamp ON DTCB2607 May Be Set
Article No.
01-6-1
04/02/01
^
BRAKES - ANTI-LOCK BRAKE LAMP
ILLUMINATED - WITH OR WITHOUT DIAGNOSTIC
TROUBLE CODE (DTC) B2607 STORED IN
MEMORY - SPORT AND SPORT TRAC VEHICLES
ONLY
^
ELECTRICAL - ANTI-LOCK BRAKE LAMP
ILLUMINATED - WITH OR WITHOUT DIAGNOSTIC
TROUBLE CODE (DTC) B2607 STORED IN
MEMORY - SPORT AND SPORT TRAC VEHICLES
ONLY
^
LAMP - ANTI-LOCK BRAKE LAMP ILLUMINATED -
WITH OR WITHOUT DIAGNOSTIC TROUBLE CODE
(DTC) B2607 STORED IN MEMORY - SPORT AND
SPORT TRAC VEHICLES ONLY
FORD:
2001 EXPLORER
ISSUE
The Anti-lock Brake System (ABS) lamp may illuminate and Diagnostic Trouble Code (DTC) B2607 may or may not be set in the ABS module on some
Sport and Sport Trac vehicles. The ABS lamp may remain on or may illuminate intermittently. This may be due to the ABS module remaining active
when the engine is cranked and both blower motors are on.
ACTION
Replace the ABS module with an updated module if existing module is the original design, and check for proper circuit grounding. Refer to the following
Service Procedure for details.
SERVICE PROCEDURE
It the ABS lamp is on intermittently:
1.
Replace the ABS module.
a.
4X4 vehicle: Replace the module with part number 1L5Z-2B373-AB. Refer to the 2001 Explorer Workshop Manual, Section 206-09 for
installation instructions.
b.
4X2 vehicle: Replace the module with part number 1L5Z-2B373-BB. Refer to the 2001 Explorer Workshop Manual, Section 206-09 for
installation instructions.
2.
Test drive vehicle to verify repair.
If the ABS lamp is on continuously:
1.
Replace the ABS module.
a.
4X4 vehicles: Replace the module with part number 1L5Z-2B373-AB. Refer to the 2001 Explorer Workshop Manual, Section 206-09 for
installation instructions.
b.
4X2 vehicles: Replace the module with part number 1L5Z-2B373-BB. Refer to the 2001 Explorer Workshop Manual, Section 206-09 for
installation instructions.
2.
Turn the key to the Run position for 5 seconds.
a.
If ABS lamp remains on after bulb check, continue with Step 3.
