Explorer Sport 4WD V6-245 4.0L SOHC VIN K SFI (2001)
listing wire in the seat back pad.
NOTE: The seat back trim cover has been inverted for clarity.
18. Install new hog rings onto the swing rods (one shown).
19. Pull the seat backrest trim cover completely down and connect the hook and loop fastener to the seat back cushion.
20. Reattach the seat back trim cover lower J-clips.
21. Position the seat back to the seat bottom and route the wires and cables.
1
Position the seat back to the seat bottom.
2
Pull the side air bag module wire harness through the seat bottom.
3
Pull the lumbar support cable through the seat bottom.
22. Align the seat back to the seat bottom. Install the bolt.
