Explorer Sport 4WD V6-245 4.0L SOHC VIN K SFI (2001)
^
ALWAYS WEAR SAFETY GLASSES WHEN REPAIRING AN AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS) VEHICLE AND
WHEN HANDLING AN AIR BAG MODULE. THIS WILL REDUCE THE RISK OF INJURY IN THE EVENT OF AN ACCIDENTAL
DEPLOYMENT.
^
NEVER PROBE THE CONNECTORS ON THE AIR BAG MODULE. DOING SO CAN RESULT IN AIR BAG DEPLOYMENT, WHICH
CAN RESULT IN PERSONAL INJURY.
NOTE: Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the diagnostic
procedure again.
1. Slide the driver seat side air bag delete resistor onto the finger clip.
2. Connect the driver seat side air bag delete resistor.
1
Connect the driver seat side air bag delete resistor.
2
Tie-strap the wire harness in place.
3. Connect the battery ground cable.
4. Prove out the air bag system. See: Air Bag(s) Arming and Disarming
