Explorer Sport 4WD V6-245 4.0L SOHC VIN K SFI (2001)
5. Remove the restraint system diagnostic tool from the vehicle harness side of the clockspring electrical connector at the base of the steering column.
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM
VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF
VEHICLE SAFETY STANDARDS.
6. Connect the clockspring electrical connectors.
1
Connect the two clockspring electrical connectors to the vehicle harness and install the electrical connector pin-type retainers to the bracket.
2
Position the ground wire and install the bolt.
7. Route the wire harness into the two holders.
8. Install the key-in-ignition warning indicator switch to the steering column.
