Explorer Sport 4WD V6-245 4.0L SOHC VIN K SFI (2001)
^
PLEASE REFER TO THE APPROPRIATE COMPONENT OR SYSTEM TO DETERMINE LOCATION OF THE FRONT AIR BAG
SENSORS.
^
THE SIDE AIR BAG SENSORS ARE LOCATED AT OR NEAR THE BASE OF THE B-PILLAR.
^
TO DEPLETE THE BACKUP POWER SUPPLY ENERGY, DISCONNECT THE BATTERY GROUND CABLE AND WAIT AT LEAST
ONE MINUTE. BE SURE TO DISCONNECT AUXILIARY BATTERIES AND POWER SUPPLIES (IF EQUIPPED).
18. Position the passenger seat forward.
19. Remove from vehicle prior to road use. Failure to remove can result in injury and possible violation of vehicle safety standards.
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE THE
RESTRAINT SYSTEM DIAGNOSTIC TOOL FROM THE PASSENGER SEAT SIDE AIR BAG FLOOR ELECTRICAL
CONNECTOR.
20. Connect the passenger seat side air bag electrical connector and tie-strap the wire harness.
21. Position the passenger seat rearward.
22. Remove the restraint system diagnostic tool from the vehicle harness side of the passenger air bag electrical connector.
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM
VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE CAN RESULT IN INJURY AND POSSIBLE VIOLATION OF VEHICLE
SAFETY STANDARDS.
23. Install the passenger air bag module.
