Explorer Sport 4WD V6-245 4.0L SOHC VIN K SFI (2001)
1. Install the rear safety belt retractor.
1
Position the safety belt retractor.
2
Using the special tool, install the bolt.
NOTE: Make sure to tighten nuts and bolts to specification.
2. Install the C-pillar trim panel.
1
Position the C-pillar trim panel and feed the safety belt webbing through the opening.
2
Align the C-pillar trim panel and push in, fastening the retainers.
NOTE: Make sure the safety belt webbing is not twisted prior to installation.
3. Install the C-pillar trim panel pin-type retainer.
4. Install the rear safety belt guide.
1
Position the rear safety belt guide.