Explorer Sport 4WD V6-245 4.0L SOHC VIN K SFI (2001)
Fuel Tank Pressure Sensor: Service and Repair
REMOVAL
1. Remove the fuel tank.
2. Remove the fuel tank pressure sensor.
1
Disconnect the electrical connector.
2
Press down and rotate the fuel tank pressure sensor counterclockwise and remove it from the fuel tank.
CAUTION: The fuel tank pressure sensor must be disengaged from the fuel tank before it can be removed. Push down and rotate the fuel tank
pressure sensor counterclockwise to disengage it from the fuel tank. Failure to do so can cause damage to the fuel tank pressure sensor or the fuel
tank.
INSTALLATION
1. To install, reverse removal procedure.
^
Leak test. See: Powertrain Management/Emission Control Systems/Evaporative Emissions System/Testing and Inspection/Component Tests
and General Diagnostics/Component Tests/Evaporative Emission System Leak Test
^
Carry out the evaporative emissions repair verification drive cycle. See: Powertrain Management/Emission Control Systems/Evaporative
Emissions System/Testing and Inspection/Component Tests and General Diagnostics/Component Tests/Evaporative Emission Repair
Verification Drive Cycle