Explorer Sport 4WD V6-245 4.0L SOHC VIN K SFI (2001)
Band Apply Servo: Adjustments
Front Band Adjustment
Front Band Adjustment
Special Tools
Special Tool(s)
1. Raise the vehicle on a hoist.
2. Disconnect the shift cable.
1. Disconnect the shift cable from the manual control lever.
2. Disconnect the shift cable from the bracket.
3. CAUTION:
^
Do not allow front band adjustment screw to back out. Band strut can fall out of position;
^
Throw the locknut away. The locknut is not reusable for assembly.
Remove and discard the locknut.
4. CAUTION:
^
Install, but do not tighten, a new locknut on the band adjustment screw. Apply petroleum jelly to the locknut seal.
^
The servo must be installed prior to band adjustment.
NOTE: The wrench will click at the specified torque. Install new locknut, do not tighten at this time.
