Explorer Sport 4WD V6-245 4.0L SOHC VIN K SFI (2001)
Band Apply Servo: Adjustments
Intermediate Band Adjustment
Intermediate Band Adjustment
1. Raise and support the vehicle.
2. Remove the shift cable.
1. Disconnect the shift cable from the manual control lever.
2. Remove the shift cable from the bracket.
3. Remove the digital Transmission Range (TR) sensor.
4. CAUTION:
^
Do not allow the screw to back out. Band strut can fall out of position.
^
Throw the locknut away. The locknut is not reusable for assembly.
Remove and discard the locknut.
5. CAUTION:
^
Install, but do not tighten, a new locknut on the screw. Apply petroleum jelly to the locknut seal.
^
The intermediate servo must be installed prior to band adjustment.
NOTE: The wrench will click at the specified torque. Install new locknut, do not tighten at this time.
Using the special tool, tighten the screw then, back off the screw exactly two (2) turns and hold that position.