Explorer Sport 4WD V6-245 4.0L SOHC VIN K SFI (2001)
Install the extension housing.
1. Position the extension housing.
2. Install the extension housing screws.
3. Install the extension housing stud.
6. If equipped, install the transfer case.
7. NOTE: Align the drive shaft with the marks made during removal to ensure correct balance.
Install the rear driveshaft bolts.
8. NOTE:
^
Make sure the tab is in the lock position.
^
Install new O-rings on the transmission case (16 pin) electrical connector.
Install the transmission case (16 pin) electrical connector.
^
Lubricate the transmission case (16 pin) electrical connector O-rings with petroleum jelly.
9. Press the transmission case (16 pin) electrical connector through the case until a click is heard.
10. CAUTION: Align the slot on the TSS Sensor electrical connector with the slot in the 16 pin case connector.
