Explorer Sport 4WD V6-245 4.0L SOHC VIN K SFI (2001)
1.
Raise the vehicle on a hoist.
2.
Inspect the three front axle mounting bolts. The vertical mounting bolt has a large washer; the right and left horizontal mounting bolts do not have
a washer. See Figure 1.
^
If the correct bolts have been installed, no repair is required. Lower and release the vehicle.
^
If the incorrect bolt(s) have been installed in any of the three locations, the incorrect bolt(s) must be replaced with the correct (new) bolt and a
new nut. Go to Mounting Bolt Replacement.
^
If any bolt(s) is missing, follow the steps in Inspection and Installation for Missing Mounting Bolts.
MOUNTING BOLT REPLACEMENT
NOTE:
If more than one incorrect bolt was identified, replace them one at a time.
1.
Position a jackstand under the front axle, below the mount with the incorrect bolt.
2.
Remove and discard the incorrect bolt and nut.
3.
Install the correct (new) bolt (vertical bolt N81 1242-S426; horizontal bolt N808403-S426) and a new nut (N811623-S426). Tighten to 70 Nm (52
lb-ft).
4.
Remove the jackstand and repeat steps 1-3 as necessary.
5.
Lower and release the vehicle.
INSPECTION AND INSTALLATION FOR MISSING MOUNTING BOLTS
NOTE:
Perform this procedure only if the vehicle is missing a mounting bolt(s). If more than one mounting bolt is missing, install them one at a time.
