Explorer Sport 4WD V6-245 4.0L SOHC VIN K SFI (2001)
1.
Inspect the horizontal mounting bushings and constant velocity joint boots for tears or missing chunks. Inspect the axle halfshaft for signs of
damage. Also, inspect the area of the torsion bar as indicated in the illustration for missing paint or nicks from contact with the halfshaft. See
Figure 2.
^
If any damage is found, contact the Special Service Support Center at 1-800-325-5621 for further instruction.
^
If damage is not found, go to step 2.
2.
Position an adjustable jackstand under the front axle below the mount with the missing bolt.
3.
Raise the axle up until the center of the bushing is aligned with the hole in the frame.
4.
Install the correct (new) bolt (vertical bolt N811242-S426; horizontal bolt N808403-S426) and new nut (N811623-S426). Tighten to 70 Nm (52
lb-ft).
5.
Remove the jackstand, and repeat steps 2-4 as necessary.
6.
Lower the vehicle.
7.
Test drive the vehicle in 4x2 and 4x4 mode.
^
If any abnormal noise is heard coming from the front axle or halfshafts, contact the Special Service Support Center at 1-800-325-5621 for
further instruction.
^
If abnormal noise is not present, release the vehicle to the owner.
