Explorer Sport 4WD V6-245 4.0L SOHC VIN K SFI (2001)
3. Install the (RH) transmission mount bolt.
1. Position the exhaust bracket.
2. Install the bolt.
4. Position the crossmember and install the six bolts and nuts.
5. Remove High-Lift Transmission Jack.
6. Install the nuts.
7. NOTE: To maintain initial driveshaft balance, align the index marks on the driveshaft and the rear axle pinion flange made during removal.
Install the rear driveshaft.
8. Install the drain plug.
9. Refill the transmission with the specified amount of fluid.
^
Use MERCON(R) Multi-Purpose Automatic Transmission Fluid XT-2-QDX or equivalent meeting Ford specification MERCON(R).
10. Lower the vehicle.
