Explorer Sport 4WD V6-245 4.0L SOHC VIN K SFI (2001)
Position the flange on the rear output shaft. If necessary, reseat the oil seal in the flange.
5. Using the special tool, install the flange. Tighten the nut on the special tool to 54 Nm (40 ft. lbs.) to seat the flange on the shaft.
6. Use the special tool to prevent the flange from turning. Install the washer and the new nut.
7. CAUTION: Align the index marks.
NOTE: Install the driveshaft with new bolts. If new bolts are not available, coat the threads of the original bolts with Threadlock and Sealer
EOAZ-19554-AA or equivalent meeting Ford specification WSK-M2G351-A5.
Connect the driveshaft to the transfer case and install the bolts.
8. Check, and if necessary, fill the transfer case to the correct level with the specified fluid.
9. Lower the vehicle.
