Explorer Sport 4WD V6-245 4.0L SOHC VIN K SFI (2001)
Back Window Glass: Service and Repair
Power
REMOVAL
1. Remove the C-pillar trim panel.
2. Position the rear of the carpet aside.
3. Position the rear window glass regulator access panel aside.
1
Remove the screws.
2
Remove the nut.
3
Position the rear window glass regulator access panel aside.
4. Remove the rear window weatherstrip moulding.
5. Position the rear window glass to the center position using the following procedure.
1
Start with the ignition key in the OFF position.
2
Turn the ignition to the ON position.
3
Press the rear window glass control switch vent button six times.
4
Turn the ignition key to the OFF position.
5
Press the rear window glass control switch vent button six more times.
6
Turn the ignition to the ON position. At this point the rear window will move up and down approximately 20 mm (0.8 in). This movement
signifies that the rear window glass motor has entered into the initialization mode.
7
Hold the rear window glass control switch in the full up position until the rear window glass stops in the full up position.
8
Hold the rear window glass control switch in the full down position until the rear window glass stops in the full down position.
9
Hold the rear window glass control switch in the full up position until the rear window glass in the center position and release the switch.
10
Turn the key to the OFF position.
6. Remove the rear window glass bolts.
