Explorer Sport Trac 2WD V6-245 4.0L SOHC VIN K SFI (2001)
22. Install the two bolts and tighten to specification.
CAUTION: When positioning the seat or installing the bottom to the seat back, be careful not to damage the seat back pivot and any of the wires
or cables from the seat back to the seat bottom. This can cause damage to one of the seat components.
23. Route the side air bag module wire harness.
1
Slide the side air bag wire harness onto the finger clip.
2
Install the side air bag wire harness pin-type retainer into the seat bottom frame.
24. Connect the lumbar support cable assembly.
1
Install the cable end ball to the cable end retainer.
2
Insert the lumbar cable sleeve into the adjustment cable sleeve slot.
25. Install the push pin holder to the seat bottom frame and insert the lumbar support cable.
