Explorer Sport Trac 2WD V6-4.0L (2009)
Rear Bumper Cover / Fascia: Removal and Replacement
Bumper Cover - Rear, Sport Trac
1. Remove the 6 rear bumper cover screws.
-
To install, tighten to 6 Nm (53 lb-in).
2. Remove the 6 rear bumper cover splash shield screws (3 each side).
3. Disconnect the license plate electrical connector.
4. NOTICE: To avoid damaging the rear bumper cover, do not twist the cover when removing.
Remove the bumper cover.
-
Pull the outer corners outward and pull the bumper cover rearward to disengage the cover from the retaining clips.
5. Transfer the components as necessary.
6. To install, reverse the removal procedure.
