Explorer Sport Trac 2WD V6-4.0L (2009)
4. Remove the seat backrest trim cover.
5. To install, reverse the removal procedure.
Seat Backrest Cover - Second Row, 40 Percent E-Z Entry
Seat Backrest Cover - Second Row, 40 Percent E-Z Entry
Removal and Installation
1. Using an appropriate tool, push in the hole of each head restraint guide while lifting up and remove the head restraint.
2. NOTICE: Use care when separating the seat back trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from
the backrest foam pad.
Release the backrest trim cover lower J-clip, hook-and-loop strips and partially invert the trim cover.
3. Separate the kneeling mechanism release handle from the backrest frame.
-
Release the 3 kneeling mechanism release handle clips and separate from the backrest frame.
-
Separating the kneeling mechanism release handle from the backrest frame can also be done by going between the backrest foam pad and
backrest frame. Release the top and side clips and push out, separating the kneeling mechanism release handle from the backrest frame.
4. NOTICE: Use care when separating the seat back trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from
the backrest foam pad.
Release the hook-and-loop strips and invert the trim cover as high as it will go.
-
Pull the kneeling mechanism release handle and cable through the backrest trim cover opening.
5. From between the backrest foam pad and the backrest frame, reach up, pinch the ends together and remove the head restraint guides.
6. Remove the backrest trim cover.
7. To install, reverse the removal procedure.
Seat Backrest Cover - Second Row, 40 Percent, Bench
Seat Backrest Cover - Second Row, 40 Percent, Bench
