Explorer Sport Trac 2WD V6-4.0L (2009)
Removal
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result
in serious personal injury.
1. Remove the wheel and tire.
2. Remove the brake flow bolt and position the brake hose aside.
-
Discard the 2 copper washers.
3. Remove the 2 brake caliper guide pin bolts and remove the brake caliper.
4. Remove the brake pads from the brake caliper.
Installation
1. Install the brake pads to the brake caliper.
2. Position the brake caliper and install the 2 guide pin brake caliper bolts.
-
Tighten to 32 Nm (24 lb-ft).
3. Using 2 new copper washers, position the brake hose and install the brake hose flow bolt.
-
Tighten to 35 Nm (26 lb-ft).
