Explorer Sport Trac 2WD V6-4.0L (2009)
Brake Hose/Line: Service and Repair
Front Disc Brake
Brake Flexible Hose
Removal and Installation
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result
in serious personal injury.
NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or
plastic surface, immediately wash the surface with water.
1. Remove the brake flexible hose flow bolt and discard the 2 copper washers.
-
To install, tighten to 35 Nm (26 lb-ft).
-
Use 2 new copper washers.
2. Disconnect the brake tube fitting from the brake flexible hose.
-
To install, tighten to 18 Nm (159 lb-in).
3. Remove the brake flexible hose retaining clip and the brake flexible hose.
4. To install, reverse the removal procedure.
-
Bleed the brake caliper.
