Explorer Sport Trac 2WD V6-4.0L (2009)
3. Through the headlight switch bezel opening, install the 2 SJB bolts.
4. If necessary, install the LH instrument panel side finish panel.
5. Connect the 2 electrical connectors and install the headlight switch bezel assembly into the instrument panel.
6. Position the parking brake control assembly and install the 3 bolts.
-
Tighten to 20 Nm (177 lb-in).
7. Install the harness clip on the parking brake cable housing.
8. Install the hood release cable pushpin into the parking brake control bracket.
9. Connect the parking brake switch electrical connector.
10. Position the parking brake release handle and install the 2 bolts.
11. NOTE: While installing the trim panel, pull the hood release lever rearward in order for the release lever to slide through the trim panel.
Position the cowl side trim panel and install the pushpin.
12. Position the LH door opening weather seal.
13. NOTE: If the SJB was not replaced, this is the last step that is necessary.
Install the driver door scuff plate.
14. NOTE: When successful, this step provides the calibration necessary for the SJB operation and clears DTC B2477. The clearing of this DTC
indicates the calibration data has been successfully downloaded to the new SJB.
NOTE: When successful, this step also programs the remote transmitters into the new SJB. In the event the remote transmitters do not program to
the new SJB, all of the remote transmitters will need to be present and refer to Locks, Remote Keyless Entry Transmitter Programming. This
action will program the remote transmitters into the new SJB.
Download the SJB configuration information from the scan tool into the new SJB. See: Accessories and Optional Equipment/Antitheft and Alarm
Systems/Keyless Entry/Keyless Entry Transmitter/Testing and Inspection/Remote Keyless Entry (RKE) Transmitter Programming
15. NOTE: When successful, this step clears DTCs B2868, B2869, B2870 and B2871. The clearing of these DTCs indicates the SJB has recognized
the tire pressure sensors during the training procedure.
Train the tire pressure sensors.
16. NOTE: DTC C2780 will not clear if any of the pre-set DTCs are still present in the SJB. When successful, this step will clear DTC C2780.
Carry out the SJB self-test (must include an on-demand) by clearing DTCs, and then retrieving DTCs to confirm all DTCs have been cleared.
