ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2819 > < Initial Inspection and Diagnostic Overview|Page 2817
Page 53
background image

GO to Q35.

No

GO to Q36.

-------------------------------------------------
Q35 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE DSM DISCONNECTED

-

Disconnect: DSM C341c.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and ground; and between the DLC C251-11, circuit
VDB07 (VT/OG), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to Q49.

No

GO to Q36.

-------------------------------------------------
Q36 VERIFY VEHICLE EQUIPMENT - SDARS MODULE

-

Inspect the vehicle for a SDARS module.

-

Is the vehicle equipped with a SDARS module?

Yes

GO to Q37.

No

GO to Q38.

-------------------------------------------------
Q37 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE SDARS MODULE
DISCONNECTED

-

Disconnect: SDARS Module C3290.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and ground; and between the DLC C251-11, circuit
VDB07 (VT/OG), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to Q50.

No

Initial Inspection and Diagnostic Overview|Page 2819 > < Initial Inspection and Diagnostic Overview|Page 2817