Explorer Sport Trac 2WD V6-4.0L (2009)
GO to R8.
No
GO to R9.
-------------------------------------------------
R8 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE DSM DISABLED
-
Disconnect: SJB Fuse 1 (20A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. Go To Pinpoint Test M. See: Pinpoint Test M: The Driver Seat Module (DSM) Does Not Respond To The Scan Tool
No
INSTALL the removed fuse. GO to R9.
-------------------------------------------------
R9 VERIFY VEHICLE EQUIPMENT - PRB MODULE
-
Inspect the vehicle for power running boards.
-
Is the vehicle equipped with power running boards?
Yes
GO to R10.
No
GO to R11.
-------------------------------------------------
R10 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE PRB MODULE DISABLED
-
Disconnect: BJB Fuse 19 (30A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. Go To Pinpoint Test N. See: Pinpoint Test N: The Power Running Board Module Does Not Respond To The Scan Tool
No
INSTALL the removed fuse. GO to R11.
-------------------------------------------------
R11 VERIFY VEHICLE EQUIPMENT - RETM APIM AND/OR SDARS MODULE
-
Inspect the vehicle for an RETM, an APIM, and/or a SDARS module.
-
Is the vehicle equipped with an RETM, an APIM and/or a SDARS module?
Yes
GO to R12.
No
GO to R14.
