Explorer Sport Trac 2WD V6-4.0L (2009)
Connect - Type II
1. Inspect and clean both spring lock coupling ends. Install new O-ring seals and garter springs if necessary.
2. NOTE: Make sure the fuel tube clicks into place when installing the tube. To make sure that the fuel tube is fully seated, pull on the tube.
NOTE: Apply clean engine oil to O-ring seals.
Fit the male end into the female end and push until the garter spring snaps over the flared end of the female end.
3. Make sure the spring lock coupling is engaged by pulling on the tube.
4. Install the fuel tube safety clip.
5. Connect the battery ground cable.
