Explorer Sport Trac 2WD V6-4.0L (2009)
1. NOTE: PCM installation DOES NOT require new keys.
Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation (PMI) procedure.
See: Computers and Control Systems/Information Bus/Testing and Inspection/Programming and Relearning
Vehicles equipped with a 4.6L (3V) engine
2. Remove the Air Cleaner (ACL).
All vehicles
3. Disconnect the RH front wheel speed sensor electrical connector. Remove the nut(s) and position the A/C tube bracket(s) and wiring harness aside.
4. Disconnect the PCM connectors.
5. Remove the 2 bolts and the PCM.
Installation
All vehicles
1. Install the PCM and the 2 bolts.
-
Tighten to 10 Nm (89 lb-in).
2. Connect the PCM electrical connectors.
3. Position the wiring harness and the A/C tube bracket(s) and install the nut(s). Connect the RH front wheel speed sensor electrical connector.
-
Tighten to 7 Nm (62 lb-in).
Vehicles equipped with a 4.6L (3V) engine
4. Install the ACL.
All vehicles
5. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation (PMI) procedure.
See: Computers and Control Systems/Information Bus/Testing and Inspection/Programming and Relearning
6. Reprogram the Passive Anti-Theft System (PATS). Carry out the Parameter Reset procedure. See: Accessories and Optional Equipment/Antitheft
and Alarm Systems/Testing and Inspection/Programming and Relearning/Passive Anti-Theft System (PATS) Parameter Reset