Explorer Sport Trac 2WD V6-4.0L (2009)
crash.
NOTICE: Prevent oil and/or grease from getting on the Occupant Classification Sensor (OCS) rail bolts as this can lead to tightening beyond
the specified torque value. Failure to follow this instruction may result in damaged or broken OCS rail bolts.
NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.
NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
1. Remove the front passenger seat.
2. NOTICE: Before releasing the Occupant Classification Sensor (OCS) rail electrical connector, push only on the tip of the connector
release tab to release the electrical connector. Do not insert the tool too deep into the OCS rail electrical connector or damage to the
electrical connector may occur.
NOTE: Note the Occupant Classification Sensor (OCS) rail position, electrical wiring routing, wiring, connector and wiring retainers for
installation.
On the affected side, detach the 2 OCS rail wiring retainers and using a suitable tool, release the tab and disconnect the OCS rail electrical
connector.
3. If equipped, disconnect the power seat track motor electrical connector.
4. Move the seat to the forward stop position.
-
If equipped with a power seat track, apply power and ground to the pins shown.
5. Remove the 2 rear bolts from the OCS rail.
6. Move the seat to the rearward stop position.
-
If equipped with a power seat track, apply power and ground to the pins shown.
