Explorer Sport Trac 2WD V6-4.0L (2009)
3. Tilt the headrest to the E-Z entry position.
4. Fold the appropriate seat and tilt forward to the E-Z entry position.
Explorer/Mountaineer with 60/40 E-Z entry and bench seat
5. Remove the upper C-trim pillar panel.
6. Position the rear quarter trim panel aside to access the safety belt retractor.
All vehicles
7. Remove the bolt and safety belt retractor anchor.
-
To install, tighten to 40 Nm (30 lb-ft).
8. Remove the bolt and D-ring.
-
To install, tighten to 40 Nm (30 lb-ft).
9. Remove the bolt and safety belt retractor.
-
To install, tighten to 40 Nm (30 lb-ft).
10. NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
To install, reverse the removal procedure.
11. Check the active restraint system for correct operation. For additional information, refer to the appropriate Functional Test procedure in Safety
Belt System See: Testing and Inspection/Component Tests and General Diagnostics.
