ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Seat Sensor/Switch > < OCS Rail 1|Page 6169
Page 1
background image

Seat Position Sensor: Service and Repair

Seat Position Sensor

NOTE: Power seat shown, manual seat similar.

WARNING: Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to
follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which
increases the risk of serious personal injury or death.

WARNING: Never probe the electrical connectors on air bag, Safety Canopy(R) or side air curtain modules. Failure to follow this instruction
may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.

NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.

1. Position the front seat to the rearmost and upward position.

2. Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering  See: Air Bag

Systems/Air Bag(s) Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering and Repowering in the General
Procedures.

3. Disconnect the seat position sensor electrical connector.

4. WARNING: Always tighten the seat position sensor retaining bolt to specified torque. Failure to do so may result in incorrect restraint

system operation, which increases the risk of personal injury or death in a crash.

Remove the bolt and seat position sensor.
-

To install, tighten to 6 Nm (53 lb-in).

5. To install, reverse the removal procedure.

6. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering  See: Air Bag

Systems/Air Bag(s) Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering and Repowering in the General
Procedures.

Seat Sensor/Switch > < OCS Rail 1|Page 6169