Explorer Sport Trac 2WD V6-4.0L (2009)
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery. For additional information, refer to Battery Disconnect See: Service and Repair/Battery Disconnect.
3. Remove the starter solenoid terminals protective cap.
4. Remove the starter solenoid wire cable terminal nut.
-
To install, tighten to 6 Nm (53 lb-in).
5. Remove the starter solenoid positive cable terminal nut.
-
To install, tighten to 12 Nm (106 lb-in).
6. Disconnect the starter solenoid wire cable terminal.
7. Disconnect the starter solenoid positive cable terminal.
8. Remove the nut and disconnect the starter motor ground cable terminal.
-
To install, tighten to 25 Nm (18 lb-ft).
9. Disconnect the power steering pressure switch electrical connector.
10. Disconnect the A/C compressor electrical connector.
11. Disconnect the oil pressure sending unit electrical connector.
