Explorer Sport Trac 2WD V6-4.0L (2009)
2. With the vehicle in NEUTRAL, position it on a hoist.
3. Remove the power steering pump pulley. For additional information, refer to Power Steering Pump Pulley - 4.0L See: Power Steering Pump
Pulley.
4. Remove the pressure line bracket-to-engine bolt.
5. Remove the power steering pump supply hose bracket bolt.
6. Release the power steering pump supply hose clamp and disconnect the hose.
7. Disconnect the pressure line-to-pump fitting.
-
Remove and discard the Teflon(R) seal.
8. Remove the 3 bolts and the power steering pump.
Installation
1. NOTE: A new Teflon(R) seal must be installed.
Using the Teflon(R) Seal Installer Set, install a new Teflon(R) seal to the pressure line fitting.
2. Position the power steering pump and install the 3 bolts.
-
Tighten to 25 Nm (18 lb-ft).
3. Connect the pressure line-to-pump fitting.
-
Tighten to 65 Nm (48 lb-ft).
4. Connect the power steering pump supply hose.
5. Install the power steering pump supply hose bracket bolt.
-
Tighten to 11 Nm (97 lb-in).
6. Install the pressure line bracket-to-engine bolt.
-
Tighten to 11 Nm (97 lb-in).
7. Install the power steering pump pulley. For additional information, refer to Power Steering Pump Pulley - 4.0L See: Power Steering Pump Pulley.
8. Fill the power steering system.