Explorer Sport Trac 2WD V6-4.0L (2009)
Suspension Spring ( Coil / Leaf ): Overhaul
Front Suspension - Rear Wheel Drive (RWD)
Shock Absorber and Spring Assembly
Disassembly and Assembly
WARNING: Do not apply heat or flame to the shock absorber or strut tube. The shock absorber and strut tube are gas pressurized and could
explode if heated. Failure to follow this instruction may result in serious personal injury.
WARNING: Keep all body parts clear of shock absorbers or strut rods. Shock absorbers or struts can extend unassisted. Failure to follow this
instruction may result in serious personal injury.
NOTICE: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may result
in major service expense. New parts must be installed with the same part numbers or equivalent part, if replacement is necessary. Do not use a
replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct
retention of these parts.
1. Remove the shock absorber and spring assembly. For additional information, refer to Shock Absorber and Spring Assembly.
2. Using a suitable spring compressor, compress the spring until the tension is released from the shock absorber.
3. NOTICE: When installing the shock rod nut, make sure the shock rod and bushing are centered in the upper mount before tightening the
