Explorer Sport Trac 2WD V6-4.0L (2009)
Removal
WARNING: Do not apply heat or flame to the shock absorber or strut tube. The shock absorber and strut tube are gas pressurized and could
explode if heated. Failure to follow this instruction may result in serious personal injury.
WARNING: Keep all body parts clear of shock absorbers or strut rods. Shock absorbers or struts can extend unassisted. Failure to follow this
instruction may result in serious personal injury.
NOTICE: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may result
in major service expense. New parts must be installed with the same part numbers or equivalent part, if replacement is necessary. Do not use a
replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct
retention of these parts.
NOTICE: Orientation of the suspension fasteners is important. Make sure the fasteners are installed in the same direction as when removed or
incorrect clamp load and damage to components may occur.
1. Measure the distance from the center of the hub to the lip of the fender with the vehicle in a level, static ground position (curb height).
2. Remove and discard the 3 shock absorber upper mount nuts.
3. Remove the wheel and tire.
4. Using a suitable jack, support the lower control arm near the lower ball joint.
5. Remove and discard the stabilizer bar link nut and grommet and then remove the stabilizer bar link.
