Explorer Sport Trac 2WD V6-4.0L (2009)
1. Using the scan tool, monitor the Transmission Fluid Temperature (TFT).
2. Start the engine.
3. NOTE: Engine idle speed is approximately 650 rpm.
Run the engine until the TFT is between 27-49°C (80-120°F).
4. Move the selector lever slowly through each gear, stopping in each position and allowing the transmission to engage.
5. Place the selector lever in the PARK position.
6. With the engine running and the vehicle set as close to level as possible, position it on a hoist.
7. Hold the larger transmission fluid drain plug with a wrench and remove the small (center) transmission fluid level indicating plug.
8. Install the Fluid Level and Fill Plug Adapter into the pan.
9. NOTE: Prior to filling the Fluid Transporter/Evacuator/Injector with transmission fluid, make sure that the canister is clean.
Fill the Fluid Transporter/Evacuator/Injector with transmission fluid.
10. Hang the Fluid Transporter/Evacuator/Injector under the vehicle. Position it upright and close to the transmission.
