Explorer Sport Trac 2WD V6-4.0L (2009)
7. Remove and discard the lower arm outboard bolt.
-
To install, tighten to 275 Nm (203 lb-ft) at curb ride height.
8. Remove and discard the 3 wheel knuckle bolts.
-
To install, tighten to 275 Nm (203 lb-ft).
9. Pivot the wheel knuckle assembly upward on the upper arm outboard bolt.
-
Loosen the upper arm bolt to prevent bushing damage.
-
To install, tighten to 275 Nm (203 lb-ft) at curb ride height.
10. Using the Halfshaft Remover and Handle, disengage the inboard CV joint housing from the differential side gear.
11. Remove the halfshaft assembly.
12. NOTICE: Do not tighten the wheel hub nut with the vehicle on the ground. The nut must be tightened to specification before the vehicle
is lowered onto the wheels. Wheel bearing damage will occur if the wheel bearing is loaded with the weight of the vehicle applied.
NOTE: Apply the brake to keep the halfshaft from rotating.
Position the halfshaft in the hub and use the previously removed hub nut to seat the halfshaft.
-
Tighten to 350 Nm (258 lb-ft).
