Explorer Sport Trac 2WD V6-4.0L (2009)
7. Loosen but do not remove the TR sensor screws.
8. Using the TR Sensor Alignment Gauge, align the TR sensor and tighten the screws in an alternating sequence.
-
Tighten to 8 Nm (71 lb-in).
9. Install the manual control lever and manual control lever nut.
-
Tighten to 48 Nm (35 lb-ft).
10. NOTICE: To prevent selector lever cable damage, do not apply force to the selector lever cable between the manual control lever and the
selector lever cable bracket.
NOTE: When installing the selector lever cable end, make sure that the selector lever cable end is correctly installed onto the manual control lever
ball stud. Pull back on the selector lever cable to make sure that the selector cable end is correctly installed onto the manual control lever ball stud.
Install the selector lever cable end onto the manual control lever ball stud.
11. Reconnect the TR sensor connector.
