Explorer Sport Trac 2WD V6-4.0L VIN E (2002)
24.
Remove and discard the lower bolt from the recliner assembly. See Figure 9.
25.
Install the new lower bolt (Bolt B) into the recliner assembly. Tighten the bolt to 45 Nm (33 lb-ft).
26.
Install the seat cushion side shield as follows:
^
Align and snap the shield into place.
^
Install the two (2) removed screws.
^
Install the lumbar support adjuster knob.
27.
NOTE: If the vehicle is not equipped with side air bags, no further service is required. Turn the ignition switch from OFF to RUN.
28.
Install the airbag fuse and then install the fuse box cover.
29.
WARNING: BE SURE THAT NOBODY IS IN THE VEHICLE AND THAT THERE IS NOTHING BLOCKING OR SET IN FRONT OF
ANY AIRBAG MODULE WHEN THE BATTERY NEGATIVE CABLE IS CONNECTED.
Connect the battery negative cable.
30.
Position the driver seat to its original position and program the recorded preset radio stations.
