Explorer Sport Trac 2WD V6-4.0L VIN E (2002)
2. Install the seat backrest recliner roll pins.
3. Install the flexilator.
1
Position the flexilator.
2
Install the flexilator springs.
4. Install the power seat wiring harness.
1
Position the power seat wiring harness.
2
Install the pin-type retainers.
5. Install the front swing rod.
6. Install the swing rods.
NOTE: Make sure the swing rods are seated under the boarder wire in the foam near the back of the seat cushion.
7. Install the hog rings.
1
Fold back the seat cushion trim cover to the hog ring installation position.
2
Hog ring the center of the front swing rod to the tie-down rod in the seat cushion.