Explorer Sport Trac 2WD V6-4.0L VIN E (2002)
Wheel Speed Sensor: Service and Repair
Sensor, Front
Sensor-Front
Removal and Installation
1. Raise and support the vehicle.
2. Disconnect the front anti-lock brake sensor wire from the vehicle frame.
1
Disconnect the electrical connector.
2
Unclip the front anti-lock brake sensor wire from the vehicle frame.
3. Remove the front anti-lock brake sensor.
1
Remove the bolt.
2
Remove the front anti-lock brake sensor.
4. NOTE: Plug the sensor mount opening and thoroughly clean the mounting surface. Apply High-Temperature 4x4 Front Axle and Wheel Bearing
Grease E8TZ-19590-A meeting Ford Specification ESA-MIC198-A.
To install, reverse the removal procedure.