Explorer Sport Trac 2WD V6-4.0L VIN E (2002)
16. Remove the restraint system diagnostic tool from the vehicle harness side of the clockspring electrical connector at the top of the steering column.
17. Position the driver air bag module to the steering wheel.
1. Connect the driver air bag module electrical connector.
2. Position the driver air bag module to the steering wheel.
18. Install the two driver air bag module retaining bolts.
19. Install the two steering wheel back cover plugs.
20. WARNING: The restraint system diagnostic tool is for restraint system service only. Remove from vehicle prior to road use. Failure to
remove could result in injury and possible violation of vehicle safety standards.
Make sure all restraint system diagnostic tool(s) that may have been installed during the repair have been removed from the vehicle and all SRS
components are connected.
21. Turn the ignition switch from OFF to ON.
22. Install the RCM fuse F2.6 (7.5A without rear blower, 15A with rear blower) to the CJB and close the cover.
23. WARNING: Be sure that nobody is in the vehicle and that there is nothing blocking or set in front of any air bag module when the
battery ground cable is connected.
