Explorer Sport Trac 2WD V6-4.0L VIN E (2002)
22. Remove the tie-strap and disconnect the driver seat side air bag electrical connector.
23. Attach the restraint system diagnostic tool to the driver seat side air bag floor electrical connector.
All vehicles
24. Install the RCM fuse F2.6 (7.5A without rear blower, 15A with rear blower) to the CJB and close the cover.
25. Connect the battery ground cable. For additional See: Starting and Charging/Battery
Reactivation Procedure
Reactivation
All vehicles
1. Turn the ignition switch to OFF.
2. At the central junction box (CJB), located on the LH end of the instrument panel, open the kick panel cover and remove the restraints control
module (RCM) fuse F2.6 (7.5A without rear blower, 15A with rear blower) from the CJB. For additional information, refer to the wiring Diagram
Manual.
3. Disconnect the battery ground cable (14301) and wait at least one minute. For additional information, See: Starting and Charging/Battery
Vehicles with seat side air bags
4. Remove the restraint system diagnostic tool from the driver seat side air bag floor electrical connector.
