Explorer Sport Trac 2WD V6-4.0L VIN E (2002)
Crankshaft Position Sensor: Service and Repair
REMOVAL
1. Remove the Crankshaft Position (CKP) sensor.
1
Disconnect the electrical connector.
2
Remove the bolt.
3
Remove the sensor.
INSTALLATION
1. To install, reverse the removal procedure.
NOTE:
^
The new CKP sensor needs to be touching the damper. The new sensor has wear tabs that will wear off after several engine revolutions.
^
Be sure the sensor wiring is routed away from the battery cable.
