Explorer Sport Trac 2WD V6-4.0L VIN E (2002)
Vehicles with seat side air bags and power driver seat
5. Disconnect the battery ground cable and wait at least one minute.
Vehicles with full floor console
6. Remove the full floor console.
Vehicles with a restraints control module cover
7. Remove the mat, the screws and the Restraints Control Module (RCM) cover.
All vehicles
8. Remove the right-hand side RCM retaining bolts.
9. Remove the RCM.
1
Slide and disengage the two RCM electrical connector locking clips.
2
Push down to pivot the RCM electrical connector tabs and pull out to disconnect.
3
Remove the retaining bolt.
4
Remove the RCM.
INSTALLATION
WARNING: TO REDUCE THE RISK OF SERIOUS PERSONAL INJURY, READ AND FOLLOW ALL WARNINGS, CAUTIONS AND
NOTES AT THE BEGINNING OF THE REMOVAL PROCEDURE.
All vehicles
1. Position the RCM to the center tunnel area and install the three bolts hand-tight.
