Explorer Sport Trac 2WD V6-4.0L VIN E (2002)
5. Connect the driver seat side air bag electrical connector and tie-strap the wire harness.
6. Remove the restraint system diagnostic tool from the passenger seat side air bag floor electrical connector.
7. Connect the passenger seat side air bag electrical connector and tie-strap the wire harness.
Vehicles with seat side air bags and power driver seat
8. WARNING: Be sure that nobody is in the vehicle and that there is nothing blocking or set in front of any air bag module when the
battery ground cable is connected.
Connect the battery ground cable. For additional information, See: Starting and Charging/Battery
Vehicles with seat side air bags
9. Position the front seats rearward.
Vehicles with seat side air bags and power driver seat
10. WARNING: To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing or
replacing any front or side air bag supplemental restraint system (SRS) components and before servicing, replacing, adjusting or striking
components near the front or side air bag sensors, such as doors, instrument panel, console, door latches, strikers, seats and hood latches. The side
air bag sensors are located at or near the base of the B-pillar. To deplete the backup power supply energy, disconnect the battery ground cable and
wait at least one minute. Be sure to disconnect auxiliary batteries and power supplies (if equipped).
Disconnect the battery ground cable (14301) and wait at least one minute. For additional information, refer to See: Starting and Charging/Battery
All vehicles
