Explorer Sport Trac 2WD V6-4.0L VIN E (2002)
1. Connect the side impact sensor electrical connector.
1
Position the side impact sensor.
2
Connect the side impact sensor electrical connector.
2. Install the side impact sensor.
1
Position the side impact sensor with the bracket to the B-pillar.
2
Install the bolts.
WARNING: THE TIGHTENING TORQUE OF THE AIR BAG SIDE IMPACT SENSOR RETAINING BOLTS IS CRITICAL FOR
PROPER SYSTEM OPERATION.
3. Connect the battery ground cable.
4. With the restraint system diagnostic tools installed at all deployable devices, prove out the supplemental restraint system (SRS). See: Body and
Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair/Prove Out Procedure
5. Disconnect the battery ground cable and wait at least one minute.
6. Route the wire harness and attach the pin-type retainers to the B-pillar.
7. Install the RH rear quarter trim panel.
8. Reactivate the supplemental restraint system (SRS). Refer to Air Bag(s) Arming and Disarming.
WARNING: TO REDUCE THE RISK OF SERIOUS PERSONAL INJURY, READ AND FOLLOW ALL WARNINGS, NOTES, AND
INSTRUCTIONS IN THE SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEACTIVATION/REACTIVATION PROCEDURE. Refer
to Air Bag(s) Arming and Disarming.
9. With all the restraint system diagnostic tools removed, prove out the supplemental restraint system (SRS). See: Body and Frame/Interior
Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair/Prove Out Procedure
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM
