Explorer Sport Trac 2WD V6-4.0L VIN E (2002)
Fluid - A/T: Service and Repair
A/T Fluid Level Check and Condition
With Dip Stick
Check Fluid Level and Condition
CAUTION: The vehicle should not be driven if the fluid level indicator shows the fluid below the Do Not Drive mark or internal failure could result.
NOTE: Automatic transmission fluid expands when warmed. To obtain an accurate fluid level check, drive the vehicle until warmed, approximately
30 km (18.75 miles). If the vehicle has been operated for an extended period at high speeds, in city traffic, during hot weather or while pulling a
trailer. the vehicle should be turned off for about 30 minutes to allow the fluid to cool before checking.
NOTE: The transmission fluid level should be checked at normal operating temperatures, 66 - 77 °C (150 - 170 °F), on a level surface. The normal
operating temperature can be reached after approximately 32 km (20 miles) of driving. However, you can check the fluid level without driving if the
outside temperature is above 10 °C (50 °F). When the vehicle has not been driven, and the outside is above 10 °C (50 °F), the fluid level should be
between the holes on the indicator. If the transmission fluid is to be checked when the fluid is at room temperature, the fluid level indicator could
indicate that fluid should be added if the indicator is misread. If fluid is added at this time, an overfill condition could result when the vehicle reaches
operating temperature of 66 - 77 °C (150 - 170 °F).
1. Drive the vehicle 30 km (18.75 miles) or until the vehicle reaches normal operating temperatures.
2. Park the vehicle on a level surface and apply the parking brake.
3. With the parking brake applied and your foot on the brake pedal, start the engine and move the range selector lever through all the gear ranges.
Allow sufficient time for each gear to engage.
4. Place the range selector lever in (P) park and leave the engine running.
5. Remove the fluid level indicator and wipe it clean with a lint free cloth.
6. Install the fluid level indicator until it is fully seated into the filler tube.
7. Remove the fluid level indicator and inspect the fluid level. The fluid level should be in the designated area for normal and room temperature.
High Fluid Level
Fluid levels above the safe range may result in transmission failure. An overfill condition of transmission fluid may cause shift or engagement
concerns and possible damage. High fluid levels can be caused by an overheating condition. A fluid level that is too high may cause the fluid to
become aerated due to the churning action of the rotating internal parts. This will cause erratic control pressure, foaming, loss of fluid from the vent
tube and possible transmission malfunction and/or damage. If an overfill reading is indicated drain and refill the transmission.
Low Fluid Level
DO NOT DRIVE the vehicle if the fluid level is below the hole at the bottom of the fluid level indicator or not on the fluid level indicator, and the
outside temperatures are above 10 °C (50 °F). A low fluid level could result in poor transmission engagement, slipping, malfunction and/or damage.
This could also indicate a leak in one of the transmission seals or gaskets.
