Explorer Sport Trac 2WD V6-4.0L VIN E (2002)
2.
Measure 12.7 mm (0.5 in.) from the bulge in the fresh air inlet hose and, using an appropriate hose cutter, cut the end of the hose off and discard.
Make sure no debris falls into the hose. See Figure 2.
3.
Install the new fresh air inlet hose elbow assembly into the hose and position it through the splash shield opening.
4.
CAUTION: A restriction of air flow in the fresh air inlet hose may result in a slow fuel fill condition. Make sure the fresh air inlet hose is not
pinched after tie strap installation.
Secure the fresh air inlet hose to the fuel tank breather tube with a tie strap as indicated. See Figure 3.
5.
Proceed to Authorized Modifications Label and Proof of Correction Certificate in this document.
EVAPORATIVE EMISSIONS CANISTER ASSEMBLY REPLACEMENT
NOTE!
Call the Special Service Support Center if replacement of the EVAP canister is required.
NOTE!
Perform this procedure only if the vehicle arrived at the dealership with the fresh air inlet hose disconnected from the wheel well splash shield
1.
Disconnect the battery negative cable.
2.
Lower and remove the spare tire.
3.
Raise the vehicle on a hoist.
